Announcement

Collapse
No announcement yet.

Sending unsolicited messages to a client through a TCP Listener

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Sending unsolicited messages to a client through a TCP Listener

    Hello,

    We have a International customer that has an LIS system they believe (either due to technical limits or IT Policy) needs to be the TCP Client that establishes connections to our Data Manager. I know Mirth can be a TCP Listener but this configuration is typically used if the LIS has data it needs to send (aka ADT Feed).

    This customor is requesting that their LIS initiate the TCP connection to Mirth but Mirth will be the source of the information that needs to be sent to the LIS over this channel.

    My question is, if Mirth is the TCP Listener, how do we send HL7 messages (ORU) to the LIS through this Listener channel? (We can stick with the newest Mirth v3.0.0.6931 since I know it has a few more features at our disposal.) Would this require a trick using two channels and the response message?

    Here is the proposed workflow between a data manager/Mirth (DM) and an LIS.
    1. LIS initiates a TCP connection to Mirth Connect on an IP/Port. I don't believe the LIS sends any request message other than the low-level TCP connection request.
    2. When the DM has data to send, it needs to send it to the LIS.
    NOTE: it is usually the case at this point that Mirth would be the sender (not the listener).

    I am having trouble understanding how to make this work where Mirth is the Message client but is the TCP Listener.

    I hope this makes sense. I usually convince the LIS vendor that they need to be the TCP Server so Mirth can initiate connections when it has data to send.

    Thank you much.

    Mark

  • #2
    We don't support that yet, but there's an open ticket for it: MIRTH-2446

    Feel free to vote/comment on it.
    Step 1: JAVA CACHE...DID YOU CLEAR ...wait, ding dong the witch is dead?

    Nicholas Rupley
    Work: 949-237-6069
    Always include what Mirth Connect version you're working with. Also include (if applicable) the code you're using and full stacktraces for errors (use CODE tags). Posting your entire channel is helpful as well; make sure to scrub any PHI/passwords first.


    - How do I foo?
    - You just bar.

    Comment

    Working...
    X