Splitting the output result into multiple lines

[ishaik26]

I am trying to convert a flat file to X12 834 format. I am able to generate correct output, the only difference being that the whole output is coming in one line format. How can I split the output via Mirth such that I replace '~' to '~\n' for the output EDI file. Can I use the postprocessor for this conversion. If not then what can be the possible solution.

[pacmano]

This section of the forum is for the development of Mirth itself, not the development of channels on Mirth.

Screen Shot 2021-04-10 at 12.57.10 PM.png